Using The Nose Cap; Clearing A Jam - Hitachi NT 65GS Manuel D'instructions Et De Sécurité

USING THE NOSE CAP

WARNING
When attaching or detaching the nose
cap, be sure to remove your finger
from the trigger and remove the fuel
cell and the battery from the nailer.
If you like to protect the surface of workpiece
against scratches or markings made by the
push lever, attach the accessory nose cap to
the push lever.
1 Remove the fuel cell and the battery from
the nailer.
2 Put the nose cap to the toe of the push
lever.
3 The nose cap is marked to indicate the
exit point of the nail, making alignment
easier.
4 When not using the nose cap, secure in
the storage compartment located on the
reverse side of the magazine.
Nose Cap
2
Push Lever
Nose Cap
Magazine
NT65GS, NT65GA, NT65GB
Nose Cap
Magazine
NT50GS
NOTE:
The nose cap may reduce nailing depth
due to its thickness. Re-adjustment of
nailing depth is required.

CLEARING A JAM

If nails are jammed in firing head, remove it,
and adjust the nailing in the following order.
CAUTION
Remove the fuel cell and the battery
from the Nailer.
1 Remove the fuel cell and the battery from
the Nailer.
2 Remove all nails.
English
Push Lever
Nose Cap
29