Before Operation - Hitachi NT 65GS Manuel D'instructions Et De Sécurité

Masquer les pouces Voir aussi pour NT 65GS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Table 2
Rechargeable
Temperature at which the
batteries
battery can be recharged
EBM315
32°F — 122°F (0°C — 50°C)
Regarding recharging time
Table 3 shows the recharging time
required according to the type of battery.
Table 3 Recharging time (approx. min.) at 20°C
Battery capacity (Ah)
Battery
voltage (V)
3.6
EBM315
NOTE: The recharging time may vary
according
temperature and the power supply
voltage.
5. Disconnect battery charger from the
receptacle or cigarette lighter socket.
CAUTION
Do not pull the plug out of the
receptacle by pulling on the cord.
Make sure to grasp the plug when
removing from receptacle to avoid
damaging cord.
6. Remove the battery from the battery
charger.
Supporting the battery charger with
hand, pull out the battery from the battery
charger.
Do not leave the battery charger or
battery in the car.
Regarding electric discharge in case of
new batteries, etc.
As the internal chemical substance of
new batteries and batteries that have not
been used for an extended period is not
activated, the electric discharge might be
low when using them the first and second
time. This is a temporary phenomenon,
and normal time required for recharging
will be restored by recharging the
batteries 2 – 3 times.
20
1.5 Ah
60 min.
to
the
ambient
How to make the batteries perform
longer.
Recharge the batteries before they
become completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use
the tool and exhaust the electric current,
the battery may be damaged and its life
will become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot
immediately after use. If such a battery
is recharged immediately after use, its
internal chemical substance will
deteriorate, and the battery life will be
shortened. Leave the battery and
recharge it after it has cooled for a while.
CAUTION
When the battery charger has been
continuously used, the battery
charger will be heated, thus
constituting the cause of the failures.
Once the charging has been
completed, give 15 minutes rest until
the next charging.
If the battery is recharged when it is
warm due to battery use or exposure
to sunlight, the pilot lamp may not
light.
The battery will not be recharged. In
such a case, let the battery cool before
charging.
If the battery charger does not work
while the battery is mounted
correctly, it is probable that the
battery or charger is malfunctioning.
Take it to your authorized Service
Center.

BEFORE OPERATION

Read section titled "SAFETY" (pages 5 – 12).
Make sure of the followings before
operation.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nt 65gaNt 65gbNt 50gs

Table des Matières