Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. STORE NAILER PROPERLY WITH FUEL
CELL AND BATTERY REMOVED.
120°F MAX
(50°C)
Keep the Nailer, fuel cell and battery out
of direct sunlight and out of in a vehicle.
Keep out of reach of children. Look the
storage area.
11. KEEP WORK AREA CLEAN.
Cluttered areas invite injuries. Clear all
work areas of unnecessary tools, debris,
furniture, etc.
12. KEEP VISITORS AWAY.
Do not let visitors handle the Nailer.
All visitors should be kept safely away
from work area.
13. DRESS PROPERLY.
Do not wear loose clothing or jewelry as
they can be caught in moving parts.
Rubber gloves and nonskid footwear are
recommended when working outdoors.
Wear protective hair covering to contain
long hair.
14. CHECK PUSH LEVER BEFORE USE.
The Push Lever and Chamber operate in
conjunction for this device.
Remove fuel cell and battery, and then
make sure the push lever operates
properly. (The push lever may be called
"Safety".) Never use the Nailer unless the
push lever is operating properly,
otherwise the Nailer could drive a
fastener unexpectedly. Do not tamper
with or remove the push lever, otherwise
the push lever becomes inoperable.
Pull the Feeder knob with the device
facing upward and press down the Push
lever then confirm that the Push lever
securely returns to its original position.
SAFETY
When not in use, the
Nailer, fuel cell and
battery should be
store in tool case and
in a dry place.
Store
indoors
temperature below
120°F (50°C).
— Continued
WARNING
The Push lever operation becomes
especially heavy in low temperatures and
drive operations may not function.
15. KEEP ALL SCREWS AND COVERS
TIGHTLY IN PLACE.
Keep all screws and covers tightly
mounted.
at
periodically.
Never use the Nailer if parts are missing
or damaged.
16. DO NOT LOAD FASTENERS WITH
TRIGGER OR PUSH LEVER DEPRESSED.
When loading fasteners into the Nailer,
1) do not depress the trigger;
2) do not depress the push lever; and
3) keep the Nailer pointed downward.
17. KEEP FACE, HANDS AND FEET AWAY
FROM FIRING HEAD DURING USE.
Never place your face, hands or feet
closer than 8 inches (200 mm) from the
firing head.
A serious injury can result if the fasteners
are deflected by the workpiece, or are
driven away from the point of entry.
18. PLACE
WORKPIECE.
Do not drive fasteners on top of other
fasteners or with the Nailer at too steep
of an angle; the fasteners can ricochet
and hurt someone.
19. DO NOT DRIVE FASTENERS INTO THIN
BOARDS OR NEAR CORNERS AND
EDGES OF WORKPIECE.
The fasteners can be driven through or
away from the workpiece and hit
someone.
20. NEVER DRIVE FASTENERS FROM BOTH
SIDES OF A WALL AT THE SAME TIME.
The fasteners can be driven into and
through the wall and hit a person on the
opposite side.
Check
their
NAILER
PROPERLY
English
condition
ON
7
Publicité
Table des Matières
