Working Environment; Cold Weather Care - Hitachi NT 65GS Manuel D'instructions Et De Sécurité

WORKING ENVIRONMENT

WARNING
120°F MAX
(50°C)

COLD WEATHER CARE

Do not store the Nailer, fuel cell and
battery in a cold weather environment.
Keep the Nailer, fuel cell and battery in a
warm area until beginning the work.
If the Nailer, fuel cell and battery are
already cold, bring it in a warm area and
allow the Nailer to warm up before use.
Observe temperature limit of max. 120°F
(50°C).
Do not expose to an open flame and
sparks!
CAUTION
This Nailer may not drive completely
below when; at low temperature fuel
cell loose the required propellant
force, at high temperature fuel cell
overdose.
Do not use the Nailer in the rain or
where excessive moisture is present.
This Nailer is not recommended for
use at altitudes above 5,000 feet
(1,500 m), or in temperature below
30°F (0°C).
No flammable
gas, liquid or other
flammable objects
at worksite.
Use outside or
well–ventilated
areas.
Do not inhale.
Keep the Nailer,
fuel cell and
battery away from
sunshine and
from temperature
exceeding 120°F
(50°C).
Keep away from
ignition sources.
No smoking.
Clear the area of
children or
u n a u t h o r i z e d
personnel.
PREPARING THE FUEL CELL
Read section titled "SAFTY, IMPORTANT
SAFETY INSTRUCTIONS FOR FUEL CELL"
(page 9).
CAUTION
If the gas leaks from the metering
valve or the gas cartridge after
attached the metering valve, replace
with the new metering valve.
Do not attempt to reuse the metering
valve.
Replace with the new metering valve.
To attach the metering valve to a fuel cell:
(1) Separate the metering
English
DANGER
The fuel cell is
flammable.
Keep away from
ignition sources.
Do not spray to a
naked flame or
any incandescent
material.
Do not smoke
when handling
fuel cell.
Keep stem of fuel
cell away from
face or skin.
Expanding gases
cause
temperatures. Do
not contact with
gases.
Do not inhale.
Keep out of reach
of children.
valve and the cap from
the gas cartridge.
low
21