Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
ADJUSTING THE NAILING DEPTH
Make sure that the trigger is turned off and the
battery has been disconnected before adjusting
the adjuster.
The nailing depth can be adjusted by rotating the
adjuster.
Deep
Fire a test nail and if it is driven in too deep, adjust the
depth by rotating the adjuster toward the shallower
(
mark).
If the nail is not driven in deep enough, rotate the
adjuster toward the deeper (
Too Deep
(Turn towards
Flush
shallow)
The adjuster modifi es the depth by 0.75 mm each
time it is rotated.
USING THE BELT HOOK
● Make sure the battery removed when using
the hook. Pay suffi cient attention so that the
main equipment does not fall.
If the toll falls, there is a risk of accident.
Hook can be installed on the left or right side.
22
WARNING
Adjuster
Shallow
mark).
Too Shallow
(Turn towards
deep)
WARNING
(1) Removing the hook.
Remove the screws fi xing the hook with Philips
screw driver.
Hook
Screw
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
Hook
Screw
USING THE NOSE CAP
● When attaching or detaching the nose cap,
be sure to remove your fi nger from the trigger
and remove all remaining fasteners and the
battery from the nailer.
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
This product is equipped with two types of nose caps.
Change nose caps as required.
Groove Driving
Suitable for driving into
the groove of a base
board.
Groove
WARNING
Flat Driving
Suitable for fl at driving
into soft materials such
as cedar.
Publicité
Table des Matières
