Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
5 DISCONNECT AIR HOSE FROM NAILER.
6 Choose a suitable position for the adjuster.
2
Turn Adjuster
Too Deep
2
Too Shallow
Turn Adjuster
Using the blow nozzle
●
Be sure to release your fi nger from
the trigger before using the blow
nozzle.
●
Do not point the air outlet at a
person.
●
Do not use the blow nozzle with the
push lever left fi t.
This Nailer has a blow nozzle that blows out
wood shavings which occur during work.
Press the knob with your thumb to use the blow
nozzle, as shown in the fi gure.
Air outlet
NOTE
●
When the blow nozzle is used for a long time,
the nailing force may degrade temporarily.
In this case, allows the air supply pressure
to stabilize before starting work.
16
Flush
Flush
WARNING
Knob
●
Oil in the body or drained water from the
compressor can sometimes spout out
of the air outlet. It is recommended that
you once conduct a test before use and
see if such phenomenon happens at an
environment where spouted oil will cause
any inconvenience.
Changing the exhaust direction
●
When
changing
direction,
your fi nger from the trigger and
disconnect the air hose from the
nailer.
The direction of the exhaust vent can be
changed by turning the top cover.
Exhaust
Vent
Using the nose cap
●
When
attaching
the nose cap, be sure to remove
your fi nger from the trigger and
disconnect the air hose from the
nailer.
If you like to protect the surface of workpiece
against scratches or markings made by the
push lever, attach the accessory nose cap to
the push lever.
1 DISCONNECT AIR HOSE FROM NAILER.
2 Put the nose cap to the toe of the push
lever.
3 The nose cap is marked to indicate the exit
point of the nail, making alignment easier.
4 When not using the nose cap, secure in
the storage compartment located on the
reverse side of the magazine.
WARNING
the
exhaust
be
sure
to
remove
Top Cover
WARNING
or
detaching
Publicité
Table des Matières
