Maintenance And Repair; Replacing The Lamp - Waldmann MT 208 Mode D'emploi

GB Instructions for use MT 208, ST 208/308, STE 111

Maintenance and repair

Disconnect the light from the
mains before carrying out any
maintenance or repair work! This
work may only be carried out by a
trained electrician!
The mains cable may only be re-
placed by the manufacturer!
Only parts approved by the manu-
facturer may be used as spare
parts.
10

Replacing the lamp

a) Disconnect the light from the
mains (pull plug)
b) Slide a screwdriver between the
reflector casing [3.1]and the
lamp cover [3.2] (on the long
side) and push it upwards (see
Fig. 3 on page 3).
MT 208, ST 208, ST 308
See Fig. 4.
c) Rotate the lamp [4.2] by about
90° [a] (until the contact pins
become visible in the slot of the
socket [4.1]).
d) Take the lamp out towards the
bottom [b].
Fig. 4
4.2
4.1
a
b
STE 111
see Fig. 5.
c) Pull the lamp [5.2] horizontally
out of the socket [5.1] and take
it out towards the bottom [c].
Fig. 5
5.2
c
5.1
Waldmann
Care
Attention! Before clean the light,
pull the mains plug!
Please use a cloth impregnated with
a suitable household cleaning agent
to clean the light components.
Please ensure that the cleaning
agent used does not damage paints
and plastics.
Disposal
The light must be disposed of in
accordance with the local regula-
tions when it has reached the end
of its useful life.
Defective fluorescent lamps must
be disposed of as special waste.