Maintenance And Repairs; Replacing The Lamp - Waldmann HLC Mode D'emploi

Instructions for use HLC/HLCE/HLWC/HLWCE Instructions for use HLC/HLCE/HLWC/HLWCE
Operation
Lights without switch
The standard equipment of the
light does not include a switch of its
own. Unplug the unit to discon-
nect it from the mains.
Lights with switch
The light is switched on/off via the
rocker switch on the light handle.
Positioning
During use, the light is held by
its handle. It may be deposited
on a surface or placed upright or
suspended by means of the at-
tached strap.
The plug connector and plug ballast
unit must be positioned in such a
way that they do not represent a
risk. When using plug ballast units,
please take note of the protection
type (see notes on plug ballast
unit).
Make sure that the cable is laid
in such a way that it cannot be
damaged.
GB GB

Maintenance and repairs

Disconnect the light from the
mains before carrying out any
maintenance or repair work!This
work may only be carried out by a
trained electrician!
The mains line must be checked
regularly for damage. A defective
mains cable may only be replaced
by the manufacturer!
Only parts approved by the manu-
facturer may be used as spare
parts.

Replacing the lamp

(see also Fig. 3 on page 3)
a) Disconnect the light (pull mains
plug).
b) Press the two locking pins for
the protective tube together
(A).
c) Pull off the protective tube (B):
d) Pull the lamp out of the lamp
handle (C).
e) Insert new lamp into the lamp
socket.
f) Slide protective tube on the
handle till the two locking pins
engage.
Note:The water-proof lights (HLWC
and HLWCE) do not contain any
locking pins. The protective tube
can be pulled off directly from
the light handle using a little bit
of force.
Caution! Use only lamp types ap-
proved by the manufacturer (see
"Technical data").
Waldmann Waldmann Waldmann Waldmann Waldmann Waldmann
Care
Note: Cleaning the transparent
shade regularly guarantees a higher
luminous efficiency.
Please use a cloth impregnated
with a suitable household clean-
ing agent to clean the light com-
ponents.
Please ensure that the cleaning
agent used does not damage
paints and plastics.
Disposal
The light must be disposed of in
accordance with the local regula-
tions when it has reached the end
of its useful life.
Defective fluorescent lamps must
be disposed of as special waste.
9