Ryobi RBC430SESD Manuel D'utilisation page 27

product.
PACKING LIST
● Power head with upper boom assembly
● Lower boom with
(RBC430SESD only)
● Front handle assembly (RBC430SESD only)
● Blade guard
● Grass deflector
● Blade with cover
● Shoulder strap
● Manual
● Figure sheet
● Blade retainer nut
● Blade washer
● String head (RBC430SBD only)
● Cupped washer
● Flange washer (RBC430SBD only)
● Combination wrench
● Wrench
WARNING
If any parts are damaged or missing do not operate the
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
INSTALLING THE POWER HEAD SHAFT TO THE
ATTACHMENT
RBC430SESD
See fi gure 2.
WARNING
Never install, remove, or adjust any attachment while
power head is running. Failure to stop the engine can
cause serious personal injury.
The attachment connects to the power head shaft by
means of a coupler device.
■ Loosen the knob on the coupler of the power head
shaft and remove the end cap from the attachment.
■ Push in the button located on the attachment shaft.
Align the button with the guide recess on the power
English (Original instructions)
string head assembly
25
head coupler and slide the two shafts together. Rotate
the attachment shaft until the button locks into the
positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
■ Tighten the knob securely.
WARNING
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious personal injury.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
For removing or changing the attachment:
■ Loosen the knob.
■ Push in the button and twist the shafts to remove and
separate ends.
ATTACHING THE HANGER CAP
RBC430SESD
See fi gure 3.
There are two ways to hang your attachment for storage.
■ To use the hanger cap, push in the button and place
the hanger cap over the lower end attachment shaft.
Slightly rotate the cap from side to side until the button
locks into place.
■ The secondary hole in the attachment shaft can be
used for hanging purposes as well.
ATTACHING THE FRONT HANDLE
RBC430SESD
See fi gure 4.
■ Remove the securing bolts and clamp from the front
handle.
■ Align the hooks on the clamp into the upper shaft slot.
■ Install the front handle onto the upper shaft.
NOTE: The front handle should tilt slightly towards the
operator when correctly fi tted.
■ Place the securing bolts through the front handle and
securely tighten them into the captive nuts on the
bracket.
NOTE: Do not attempt to remove the hooks on the clamp,
the hooks limit the upper position of the front handle.
ATTACHING THE BIKE HANDLE
RBC430SBD
See fi gure 2.
NOTE: The throttle trigger must be mounted on the
operator's right side.