Removing The Appliance; Conversion To Another Type Of Gas - Gaggenau VG 231 CA Instructions D'installation

Some yellow streaking is normal during the initial
start-up. Allow unit to operate 4-5 minutes and re-
evaluate before making adjustments.

Removing the appliance

Disconnect the appliance from the power and the gas
supply. Push out the appliance from below.
,
CAUTION:
Risk of damage! Do not lever out the
appliance from above.
8

Conversion to another type of gas

This gas stovetop corresponds to the categories
specified on the rating plate. By changing nozzles, it
is possible to convert the appliance to any of the
gases listed on the plate. The conversion kit can be
obtained from our customer service. With some
models, the conversion kit is included in the scope of
delivery.
Only a licensed specialist is authorized to switch the
appliance to another gas type.
Before carrying out the conversion, turn off the
electricity and gas supply.
Changing the low burn nozzle:
1
Remove pan support and all burner parts.
2
Unscrew two fastening screws (Torx T20) and
remove stovetop.
3
Remove control knob. Remove control panel:
Unscrew the two upper, lateral fastening screws
(Torx T20). Raise control panel in the rear and
push it forward. Remove switch cover.
4
The low burn nozzle is located in the gas valve
and is screwed in from above. For easier
accessibility, turn switch or remove securing ring
and remove switch. Unscrew the nozzle and insert
the new nozzle as specified in the low-setting
nozzle table. The nozzle must be screwed in fully.
$
5
Put switch, securing ring, switch cover and
control panel back in place and screw them tight.
Put on control knob.
Changing the full burn nozzle:
1
Remove securing clips on the burner pipes.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
2
Remove nozzle and O-ring for inner circular
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
%