Technical Data; Install Appliance; Installation Procedure; Prepare Installation Space - Gaggenau VG 231 CA Instructions D'installation

Technical Data

Total connected load electric: 0.8 VA
Gas
Pressure
C
Nozzle, full burn, outer
A
Nozzle, low burn, outer 79
D Nozzle, full burn, inner
B Nozzle, low burn, inner 42
Air gap adjustment, outer 2 mm
Total connected load
Total consumption

Installation Procedure

Prepare Installation Space

Create the cut-out in the countertop for one or several
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
Observe minimum distance between appliance
underside and furniture parts of
When installing multiple Vario appliances:
account space requirement for VV 200 connection
strip between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
(40 mm).
6
Natural Gas LPG (Propane)
Type N Type X
6" water 10" water
column column
(1.5 kPa) (2.5 kPa)
173 110 A
57
60 42
31
0 mm
18 800 BTU 17 000 BTU
(5.5 kW) (5 kW)
0.52 m³/h 364 g/h
3 / " (10 mm).
8
Take into
9
/

Install Appliance

,
WARNING:
or turn on power supply, make sure all controls
are in the OFF position.
1
Make a mark exactly in the center of the cut-out.
Fasten the mounting rails to the front and rear
edge of the cut-out. The leading edges of the
mounting rails must lie upon the worktop. The
center marking of the mounting rails must
correspond precisely with the center marking of
the cut-out.
Note:
For natural stone worktops, adhere the
mounting rails with temperature-resistant duel-
component adhesive (metal on stone).
2
For combination with the VD 201 device cover:
Mount device cover to device prior to installation
(see VD 201 Installation Instructions).
3
Insert device in cut-out. The latching lugs on the
device must lie precisely on the clamp springs.
Press device firmly into the cut-out. The latching
lugs on the device must snap into the clamp
springs.
"
16
Before you plug in an electrical cord