Before You Begin; Tools And Parts Needed; Parts Included; Countertop Requirements - Gaggenau VG 231 CA Instructions D'installation

Before You Begin

Tools and Parts Needed

▯
Phillips Head Screwdriver
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
Note:
Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.

Parts Included

Cabinet Requirements

'
$
(
)
&
%
The minimum spaces that must be maintained when
installing the gas cooktop shall be:
A
minimum 6" (150 mm)
B
minimum 6" (150 mm)
C
minimum 30" (762 mm) clearance between the
top of the cooking surface and the bottom of the
ventilation hood
D
minimum 1 9 / " (40 mm)
16
E
minimum 24" (600 mm)
F
minimum 18" (460 mm)
The distance from the top of the cooktop to the
bottom of cabinets above can be reduced to 24" when
the bottom of the wood or metal cabinet is protected
by not less than ¼" (6.35 mm)-thick flame-retardant
millboard covered with not less than No. 28 MSG
sheet metal, 0.015 inch (0.4 mm) stainless steel,
0.024 inch (0.6 mm) aluminium or copper.

Countertop Requirements

,
WARNING:
To reduce the risk of ignition of
surrounding combustible materials, install at
least 6" (150 mm) from both sidewalls and at
least 2" (50 mm) from the rear wall.
The countertop must be level and horizontal. The
stability of the countertop must be maintained after
the cut-out has been made.
¡
 PP
[
ƒ


 PP
PLQ   PP


  PP
PLQ   PP
¡
 PP
PLQ   PP
PLQ 

 PP
PLQ   PP
5