Before You Begin; Tools And Parts Needed; Parts Included; Installation Accessories - Gaggenau VG 231 220 CA Notice De Montage

en-us

Before you begin

Before you begin
T ools and parts needed
B e f o r e y o u b e g i n
Phillips Head Screwdriver
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
Tape Measure
▯
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.

Parts included

Burner grate
▯
Wok ring
▯
Burner base
▯
Burner ring
▯
Burner cap
▯
Pressure regulator
▯
1/2" U.S.A. elbow and fiber gasket
▯
Plastic covering parts for installation without
▯
appliance cover
8

Installation accessories

VD 200 020 Black appliance cover
VV 200 010 Stainless steel connection strip for
combining with other Vario 200
appliances
VV 200 020 Black connection strip for combining
with other Vario 200 appliances
Use the accessories only as indicated. The manufacturer
assumes no liability for incorrect usage of the
accessories.

Cabinet Requirements

The minimum spaces that must be maintained when
installing the gas cooktop shall be:
A minimum 12" (300 mm)
B minimum 12" (300 mm)
C minimum 30" (762 mm) clearance between
the top of the cooking surface and the
bottom of combustible constructions
D minimum 1 9 /
16
E minimum 24" (600 mm)
F minimum 18" (460 mm)
G maximum 13" (330 mm)
The distance from the top of the cooktop to the bottom of
cabinets above can be reduced to 26" when the bottom of
the wood or metal cabinet is protected by not less than
¼" (6.35 mm)-thick flame-retardant millboard covered
with not less than No. 28 MSG sheet metal, 0.015 inch
(0.4 mm) stainless steel, 0.024 inch (0.6 mm) aluminum
or copper.
" (40 mm)