Generator Safety - Speedaire SDR8CG00 Manuel D'utilisation Et De Pièces

Important Safety Information (Continued)

Generator Safety

• Be sure all powered devices are shut off prior to connecting them to the unit.
• Be sure that all tools and appliances are in good repair and are properly grounded. Use devices that have
three prong power cords. If an extension cord is used, be sure that it has three prongs for proper grounding.
• This unit may be used for emergency stand-by service. In such cases, a manual transfer switch must be
installed between the electric utilities meter and the electrical distribution box. This switch should be installed
by a licensed electrician.
Welder Safety
shock.
• Always wear dry protective clothing and welding gloves, and insulated footwear.
• Be sure that the work piece is properly supported and grounded prior to beginning any electric arc welding
operation.
• Coiled welding cable should be spread out before use to avoid overheating and damage to insulation.
attempting use!
• Always attach the work lead first.
• Verify that the work piece is securely grounded.
• Always shut off the unit when not in use and remove the electrode from the holder.
• Never allow any part of the body to touch the electrode and ground or grounded work piece at the same time.
• Awkward welding conditions and positions can be electrically hazardous. When crouching, kneeling or at
elevations, be sure to insulate all conductive parts, wear appropriate protective clothing, and take precautions
to prevent injury from falls.
• Never attempt to use this equipment at current settings or duty cycles higher than those specified on the
equipment labels.
• Never use an electric arc welder to thaw frozen pipes.
injury from flying sparks and hot metal.
• Wear ANSI compliant face shield or safety glasses with side shield protection when chipping or grinding
metal parts.
• Wear ear plugs when welding overhead to prevent spatter or slag from falling into ears.
precautions described in this manual to reduce the possibility of injury to eyes and skin.
• All persons operating this equipment or in the area while equipment is in use must wear protective welding gear
including: welding helmet or shield with at least shade 10, flame resistant clothing, leather welding gloves,
and full foot protection.
Warn others in the area not to look at the arc.
6
Always keep a fire extinguisher accessible while performing arc welding
operations.
Improper use of electric arc welders can cause electric shock, injury, and death!
Take all precautions described in this manual to reduce the possibility of electric
Never immerse the electrode or electrode holder in water. If the unit becomes wet
for any reason, be absolutely certain that it is completely clean and dry prior to
Flying sparks and hot metal can cause injury. As welds cool, slag can be thrown
off. Take all precautions described in this manual to reduce the possibility of
Electric arc welding operations produce intense light and heat and ultraviolet (UV)
rays. This intense light and UV rays can cause injury to eyes and skin. Take all
Never look at arc welding operations without eye protection as described above.
Never use a shade filter lens that is cracked, broken, or rated below number 10.