Beem Classico 03428 Mode D'emploi page 41

Masquer les pouces Voir aussi pour Classico 03428:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
EN
After it has been used several times, there is usually still water in the water system, which
means that the device is soon ready for operation.
Press the
button (16) to switch on the device and preheat the water. The control panel
fl ashes during the heating process.
Press the
button to switch off the device.
Programming Quantities
Both the quantity of espresso and the quantity of milk can be programmed for each function. This
allows you to set the perfect quantity of espresso and milk to suit your own taste.
The set quantities are saved until a new quantity is set.
Espresso, Double Espresso, Milk Froth
1. Fill the device with water and espresso or additionally with milk (see the "Preparation"
chapter).
2. Fold out the milk nozzle (8) if necessary using the lever (7) (Picture E).
3. Place a suitable cup below the coffee outlet (14) or the milk nozzle.
4. Select the function that is to be reprogrammed by pressing the appropriate button (a beep
sounds) and holding it (another beep sounds).
5. The device starts to prepare espresso or make milk froth.
6. Only let go of the button once the quantity of milk or espresso that you want has passed
through. You will hear three beeps. This quantity is now saved under the corresponding
function.
Cappuccino and Latte Macchiato
This process must be carried out twice for latte macchiato and cappuccino: Once for the
quantity of espresso and once for the quantity of milk:
1. On the fi rst operation, set the quantity of milk you want in the manner described in the
previous section. Make sure that the milk nozzle (8) is folded out and there is a cup below the
milk nozzle.
2. Start a second operation by pressing the appropriate button again. A beep sounds.
3. Wait until the quantity of milk has passed through.
4. As soon as the device starts to make espresso, press the appropriate button again and hold it
down. Another beep sounds.
5. Only let go of the button once the quantity of espresso that you want has passed through. You
will hear three beeps.
Now both the quantity of milk and the quantity of espresso are saved under the appropriate
function.
03428_DE-EN-FR-ES-IT_A5_V4.indb 30
03428_DE-EN-FR-ES-IT_A5_V4.indb 30
30
22.07.2019 10:13:22
22.07.2019 10:13:22

Publicité

Table des Matières
loading

Table des Matières