Turning The Monitor On; Starting Monitoring - Gima 35134 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour 35134:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE: when the device is working, It takes at least 10 hours to charge battery from exhaust state to 90% charged.
The provided battery of the monitor must be recharged after transportation or storage. So if the monitor is
switched on without being connected to the AC power supply, it may not work properly due to insufficient
battery power.
: Working power supply indicator and the description is as shown below.
AC power
indicator
On
Off
Status
On

3.2.2 Turning the Monitor On

The system performs self-test and enters initial display after switch on the monitor, and the alarm rings to inform that
the user can begin operating the monitor.
1. Check all the applicable functions to make sure that the monitor works normally.
2. If the built-in battery is applied, please recharge it after using the monitor to ensure sufficient power storage. It
will take at least 10 hours to charge battery from depletion to 90% charge.
3. Press the Power on/off key on the front panel of the monitor to start the monitor.
Do not use this device to monitor the patient if there are indications of damage or reminders of error. Please
contact the supplier for device.
The battery powered monitor continues to run without interruption when AC mains power is lost.
When the monitor is switched off allow one minute before switching it back on so that the monitor powers off
correctly.

3.2.3 Starting Monitoring

1. Decide which parameter measurements you want to make.
2. Connect the required modules, patient cables and sensors.
3. Check that the patient cables and sensors are correctly connected.
4. Check that the patient settings, such as Patient Type, NIBP measuring mode, etc, are appropriate to your
Operator's Manual for Patient Monitor
Name
Patient Monitor
Working power
supply indicator
Off
The monitor is powered by the AC power supply and it is in off status
On
The monitor is powered by the build-in battery power supply
The monitor is powered by the AC power supply and the battery is being
On
charged
Battery life
More than 120min
Description
18

Publicité

Table des Matières
loading

Table des Matières