Use; Operation - cookmax AP10 Manuel D'installation, Utilisation Et Entretien

of heat, such as, for example, places exposed to the sun's direct rays. The heat can damage
the surface of the appliance and adversely affect its operation.

Position the appliance so that each part of it is always at least 30 cm from walls, furniture and
other objects, in order to guarantee a good air circulation, optimum access to all parts of the
appliance and the space necessary for its operation.
During the working cycle, especially at higher speeds, the appliance may slightly
oscillate. For this reason it is important that the appliance is positioned on a sturdy,
leveled surface, at the right height so that the control panel is at an height between
80cm and 120cm from the ground level, so that the operator may work confortably
without having to assume an incorrect posture.

Do no drill holes into the appliance or attach objects to it.

The appliance must no be used if it is out of order, damaged or has suffered impacts.

Do not use the appliance without having correctly positioned the bowl and the tools in the
respective seats. Refer to subsections 5.3 and 5.4 for further information regarding the
correct sequence for fitting / removing the bowl and tools.

To avoid hazardous situations for the user do not use accessories or spare parts which differ
from those recommended by the manufacturer. The appliance could be damaged or prove to
be a risk for the health and life of individuals.

5.3 Use


Clean the appliance before its first use (see Section 6 – Cleaning and servicing).

Insert the plug in an individually interlocked protected electric socket in compliance with the
local regulations.

5.4 Operation

The appliance is operated by means of the "START" (green color) and "STOP" (red color), buttons, by
a timer that allows the operation duration (where present), and by a lever that allows to select the
planetary and tool rotation speed.
Reference should be made to sections 8 and 10 for the details regarding the control panel and the
speed to use depending on the different kind of work and products.
The user may carry out the following operations:
1. Fitting and removing bowl and tools (ref. Fig. 1 – Para. 8)
Proceed as follows, in sequence, to fit the bowl and tools:
1 – Move the side lever/wheel and lower the bowl support completely.
2 – Fit the bowl in the seat and lock it with the suited side handles. The bowl must be perfectly
secured and stable if it is correctly locked.
3 – Take the desired work tool, depending on the type of use (see Tab. 2 – Para. 10) and attach it to
the shaft of the planetary mixer, applying a slight pressure so that the tool shaft reaches the bottom
of the fixing seat. Turn the tool until it locks in its seat and check that it has been correctly secured.
4 – Move the side lever/wheel to lift the bowl (see Fig. 1 – Para. 8) up to the highest position.
29
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
- 29 -