Important; Handling And Positioning - cookmax AP10 Manuel D'installation, Utilisation Et Entretien

IMPORTANT !

In all the three-phase models, the motor rotation sense must be verified before making any other
operation. Without this check, the appliance could be damaged in case the rotation sense is
wrong. Please proceed as follow after having installed the three-phase plug:
Remove the work tool and make sure that the gear level is in position1 (
Start the appliance for just a few seconds and check that the rotation direction of the planetary
corresponds to the direction indicated by the arrow present on the head of the appliance.
In case the rotation direction should be contrary to the one indicated by the arrow, turn off the
appliance, disconnect the plug and invert the connection of two of the three phases on the plug
itself.
Check again the rotation direction of the planetary: if it corresponds to the one indicated by the
arrow, then the rotation direction is correct and you may proceed to use the appliance.
The appliance must only be connected to an electrical socket individually protected against
indirect contacts in compliance with the regulations in force in the country of use. Do not remove
the appliance's plug by pulling the power supply cable.
The power supply cable must never be placed in contact with hot objects.
Do not spray water on the appliance and do not expose it to rain, water or any other source of
humidity.
The appliance can cause injuries if it is not installed correctly. Before installing the appliance
compare the parameters of the local electricity mains supply with the technical data of the
appliance (see the nameplate fitted on the rear of the appliance, Fig. 2 – Para. 8). Only connect the
appliance to the mains if the above-mentioned data correspond! All the safety instructions must
be complied with!

Ensure that the power supply cable does not come into contact with heat sources or sharp
edges and that it does not become blocked under the appliance. Ensure that the cable is laid
out properly, and not rolled up or bent.

The power supply cable must not be laid on carpets, tablecloths, mats or on other heat
insulating materials, nor covered or immersed in water or other liquids and it must be
positioned where it cannot be walked on.

Position the appliance so that the plug is always accessible.

Do not use adapters or extensions.

5.2 Handling and positioning

Ensure that, from the point of view of the dimensions (see Tab. 1 – Par. 9), the space provided for
the appliance allows its correct use and easy servicing as indicated in section 6.

Remove the appliance from the packaging, taking care to follow the instructions in Section 4
(Environmental notes) with regard to the storage and disposal of the packaging materials.

Move the appliance taking care of doing it with the appliance's head is always lowered and
correctly locked, do not turn it upside-down andalways position it on a stable and correctly
leveled surface.

Never place the appliance on an inflammable surface (e.g. tablecloths, etc.).

Do not position the appliance close to naked flames, electric cookers, ovens or other sources
- 28 -
).
TRANSLATION OF THE ORIGINAL INSTRUCTIONS