Installing Strain Gages With Z70 Superglue - HBM K-OP Instructions D'emploi

25
Installing optical strain gages

4.2 Installing strain gages with Z70 superglue

Preparation and positioning of the optical strain gage on the measurement
object are identical to the procedure described for X60 superglue.
Fig. 4.2.1: Removing the installation aid
Once the installation aid has been removed (see Fig. 4.2.1), a mask can be
bonded on. This prevents the adhesive spreading onto the measurement
object during installation.
The optical strain gage is withdrawn a little, see Fig. 4.2.2.
Fig. 4.2.2: Withdrawing the strain gage with tweezers
A2397-3.2 en/de/fr HBM