Led/ Rel Programming; Version Display - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use

4.10.0 LED/ REL PROGRAMMING

You can make the following setting in this menu:
Adaptation of the menu to control of the colour relay module or to the colour LED module
Difference:
The relay module has 8 settable colours.
The settings are only effective on the colour operating unit which is allocated the
address 0.
Make your selection with the
Confirm your entries with the
If the operating unit is used in slave operation, the
sauna base unit must absolutely be rebooted
(disconnect the mains power supply for a short
time) to ensure that the new operating unit is
recognised.
Connected peripherals are recognised on start-up of the Wave.com4 sauna control
unit.
Only two colour operating units can be connected with the same address.
The sauna and colour operating units are address-independent of one another. A
sauna operating unit can thus have the same address as a colour operating unit.

4.11.0 VERSION DISPLAY

By simultaneously pressing the
Wave.com4 sauna control unit, the software version number of the WC4-B-L (power unit
Wave.com4 sauna control unit) is displayed for a 3-second period, .e.g. "14"
WE DO IT FIRST.
or keys.
key.
, and keys in stand-by mode of the
41 /228