Assembly Of The Wc4-B-L Power Unit; Installation Of Sensor Cables; Sensor Mounting - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use, only for experts

2.1.0 ASSEMBLY OF THE WC4-B-L POWER UNIT

Preferably mount the Wave.com4 power
unit on the cabin roof, where all wires
logically converge.
• Open the casing by loosening the screw
connection of the lid.
• Remove the lid of the Wave.com4 power unit.
• You can affix the Wave.com4 power unit to the
subfloor at the 4 corners of the chassis.

2.2.0 INSTALLATION OF SENSOR CABLES

Never install sensor and
mains cables
together.
Observe the standard
regulations in this regard.
Conscientiously install
the sensor cables in the
interest of your safety.
Conscientiously install the
sensor cables in the
Interest of a good sauna climate.

2.3.0 SENSOR MOUNTING

WE DO IT FIRST.
exterior view
Figure 23: connection of Wave.com4 power unit
Figure 24: installation of sensor cables
16 /228