Set Temperature; Eco Mode (The Mode Which Helps To Save Energy) - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

3.6.0 SET TEMPERATURE

With the
keys.
After approx 3 secs. (without pressing the keys again), the control unit automatically reverts to the
previous display (actual temperature).
Possible temperature range:
FIN
HUM
CAUTION!
The range changes when a correction value is
specified for the temperature (see 3.12.3).
After switching on the sauna heater, it is
heated up until the desired temperature is
attained.
Ventilator:
The ventilator is activated by first pressing the
extension). The ventilator is deactivated again by first pressing the
key.
The ventilator can only be switched on or off in the temperature setting mode.

3.7.0 ECO MODE (THE MODE WHICH HELPS TO SAVE ENERGY)

This new ECO mode helps you to save energy. If you wish to take a break after entering the
sauna, you can now do so. Your Wave.com4 sauna control unit with ECO function now enables
you to attain this same cabin temperature again after your break.
The following functions are possible:
• ECO20 for a 20-minute break from the sauna
• ECO40 for a 40-minute break from the sauna
• ECO60 for a 60-minute break from the sauna
Activate the ECO mode as follows:
Instructions for assembly and use
key change to the
WE DO IT FIRST.
symbol and set the desired temperature with the
<110° C
<70° C
key followed by the key (optional humidity
key followed by the
25 /228