Optional Accessories; Applications - Hitachi N 5024A2 Manuel D'instructions Et De Sécurité

OPTIONAL ACCESSORIES

Sequential Trip Mechanism Kit
(Single Shot Parts)
Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder (Code No.877153)
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change
without any obligation on the part of
HITACHI.

APPLICATIONS

Insulation sheathing.
Wire lathing.
BEFORE OPERATION
Read section titled "SAFETY" (pages 5 – 8).
Make sure of the following before operation.
WORKING ENVIRONMENT
No flammable gas, liquid or other
flammable objects at worksite.
Clear the area of children or
unauthorized personnel.
AIR SUPPLY
Never connect Stapler to pressure
which potentially exceeds 200 psi (13.7
bar 14 kgf/cm
Never use non relieving coupler on
Stapler.
... sold separately
(Code No. 876762)
(Code No.874042)
(Code No.876212)
WARNING
DANGER
NEVER
oxygen or other
bottled gases.
Explosion may
occur.
WARNING
2 ).
1. Power source
Use only
compressed air as a power source for this
Stapler.
Air compressors used to supply
compressed air to this Stapler must
comply with the requirements of the
latest version of ANSI Standard B 19.3
"Safety Standard For Compressors For
Process Industries."
Moisture or oil in the air compressor may
accelerate wear and corrosion in the
Stapler.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of
0 – 120 psi (0 – 8.3 bar 0 – 8.5 kgf/cm
Filter-regulator-lubricator units supply an
optimum condition for the Stapler and
extend the Stapler life. These units
should always be used.
Filter .............. The
Regulator ...... The regulator controls the
Lubricator ..... The lubricator supplies an
use
Stapler
side
— 11 —
English
clean, dry, regulated
filter removes
moisture and dirt mixed in
compressed air.
Drain daily unless fitted
with an automatic drain.
Keep the filter clean by
regular maintenance.
operating pressure for
safe operation of the
Stapler.
Inspect the regulator
before operation to be
sure it operates properly.
oil mist to the Stapler.
Inspect the lubricator
before operation to be
sure the supply
lubricant is adequate.
Use Hitachi pneumatic
tool lubricant.
Regulator
Compressor
side
Filter
Lubricator
2 ).
of