Adjusting The Stapling Depth - Hitachi N 5024A2 Manuel D'instructions Et De Sécurité

English
1) Do not press the stapler against the
workpiece with excessive force.
2) Separate the stapler from the
workpiece as it recoils after
stapling.
1 Pull the trigger with the Stapler off the
workpiece.
2 Depress the push lever against the
workpiece to drive a staple.
3 Move the Stapler along the workpiece
with a bouncing motion.
Each depression of the push lever will
drive a staple.
As soon as the desired number of staples
have been driven, remove finger from the
trigger.
Previously pull the trigger
3
Push lever
Keep your finger off the trigger except
during fastening operation, because
serious injury could result if the push
lever accidentally contacts you or
others in work area.
Keep hands and body away from the
discharge area. The Stapler with
contact trip mechanism may bounce
from the recoil of driving a fastener and
unwanted subsequent fastener may be
driven, possibly causing injury.
Some types of loaded staples can spark
out of the muzzle during a nail driving
operation. Exercise caution!
THE OPTIONAL
MECHANISM (SINGLE SHOT PARTS) is for
use where precision fastener placement is
desired and must be operated in accordance
with the following "Method of Operation".
1
WARNING
SEQUENTIAL
You must first depress the push lever
(upward position) where you want to
drive a staple and then pull the trigger.
After the each staple is driven, completely
release the trigger and lift the tool off the
work
SEQUENTIAL TRIP MECHANISM may
reduce the possibility of bodily injury to
you or others in the work area. This is
because it is less likely to drive an
unwanted staple if you keep the trigger
pulled and accidentally bump the push
lever against yourself or others. An
OPTIONAL
MECHANISM may also reduce the speed
of operation compared to the standard
contact trip mechanism.
NOTE:
Both STANDARD CONTACT TRIP
MECHANISM
SEQUENTIAL TRIP MECHANISM are safe
if used as described above and according
to all warnings and instructions.
Always handle staples and package
carefully. If staples are dropped, collating
bond may be broken.
After stapling:
1) disconnect air hose from the Stapler;
2) remove all staples from the Stapler;
3) supply 5 – 10 drops of Hitachi
pneumatic tool lubricant into the air
plug on the Stapler; and
4) open the petcock on the air
compressor tank to drain any
moisture.
ADJUSTING THE STAPLING
DEPTH
When adjusting the Adjuster, be sure
to remove your finger from the trigger
and disconnect the air hose from the
stapler.
To assure that each staple penetrates to the
TRIP
same depth, be sure that:
1) the air pressure to the Stapler remains
constant (regulator is installed and
working properly), and
— 16 —
surface. An
SEQUENTIAL
and
WARNING
OPTIONAL
TRIP
OPTIONAL