Stacked Installation - dB Technologies VIO-L208 Caractéristiques Techniques

STACKED INSTALLATION

• A maximum of 3 modules can be mounted in stacked configuration on DSA-VIOL208 or
AF-VIO1 frames, so they can be used on a VIO S318, S218, S118R subwoofer.
• Use the DBTECHNOLOGIES COMPOSER to set the project parameters, for safety reasons.
• Position the selected frame on the subwoofer (installed on a flat surface). For further
details on this accessory, refer to the relevant instructions.
• Add VIO-L208 modules one by one, with the previously-calculated angle, as shown in the
MECHANICS
• Make sure that the local parameters of the different modules are correctly set on the
single amplifier panels. In particular, verify according to the project, Audio Attenuation,
Speaker Coupling and High Frequency Compensation settings. As an alternative, all
parameters can be remotely edited in real time or at a later stage in case of line-array
connection through the RDNet network (DBTECHNOLOGIES NETWORK). Nevertheless,
project initial settings should at least be physically repeated on the VIO-L208 modules
before installation. For further information see
CONTROL section.
• Make the audio daisy-chain, RDNet and power connections as described in previous
paragraphs.
WARNING
•
•
VIO-L208
56
paragraph.
!
If the support surface presents
even the slightest inclination, it is
necessary to properly fasten using
the appropriate mechanical means
and/or installation straps.
This requirement is also necessary
for more than 2 subs and more
than 3 VIO-L208 modules.
DSP PRESET PARAMETERS AND REMOTE
English
Cod. 420120268 REV. 1.0