Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
CONNECTIONS
WARNING
To avoid electric shocks, ensure that your amplifier is switched off when you plug in the
loudspeaker. Before turning on the loudspeaker, be sure that the connections are correct
to avoid short circuits or wrong connections.
The connection panel at the back of the loudspeaker features two 4 pole Speakon connectors: the
first socket is the sound signal input socket and the second socket may function as an output
terminal for the connection with another loudspeaker.
The connections are:
1+
for the positive signal
1-
for the negative signal (ground)
2+
not connected
2 -
not connected
If you wish to send the amplified signal from one loudspeaker to the other, be sure that the nominal
impedance resulting from the connection is never lower than the minimum impedance of the power
amplifier. This is done to prevent overheating or, worse, damages to the amplifier.
The loudspeakers of the "DVX P" series have a nominal input impedance of 8 ohms and this must
taken into account when making the connections.
ROTATING HORN
When used horizontally, the loudspeakers of the DVX P series allow to maintain the same
coverage angle through a rotating horn.
If you wish to change the coverage angle:
- undo the fixing screws of the grille
- remove the front protective grille by slightly pressing on one side and taking the grille off the
special slots
- undo the eight fixing screws of the horn
- rotate the horn in the desired position (the horn should never be removed from the loudspeaker)
- tighten the fixing screws of the horn
- put the grille back in the special side slots and tighten the screws of the grille.
LOUDSPEAKER INSTALLATION
WARNING
Make sure that the loudspeaker is securely installed in a stable position to avoid any
injuries or damages to persons or property.
For safety reasons do not place one loudspeaker on top of another without proper
fastening systems. Before hanging the loudspeaker check all the components for
damages, deformations, missing or damaged parts that may compromise safety during
installation.
If you use the loudspeakers outdoors avoid places that are exposed to bad weather.
9
DVX P series – passive speaker
Publicité
Table des Matières
