dB Technologies VIO-L208 Caractéristiques Techniques page 39

The example shows the case in which you want to set an angle of 5° between 2 modules.
Before carrying out any other work, make sure that the hole in the selected angle is aligned once the movable
arm [6] has been inserted.
• FLOWN SCENARIO: insert only 1 pin in the hole corresponding to the angle chosen. The second pin can be
housed in the "PIN HOLDER" hole. Note that this type of configuration during assembly allows you to change
the angle without having to lift the upper module.
• STACKED SCENARIO: insert pin 1 in the hole of the chosen angle, lift module B until the movable arm [6]
allows it. Now insert the second pin into the "ANGLE LOCK" position and release module B. In this way
module B is completely blocked on the back thanks to the 2 pins.
Always make sure that all pins are fully inserted and locked at the end of assembly.
VIO-L208
38
English
Cod. 420120268 REV. 1.0