Publicité
CDI MAGNETO AND STARTER CLUTCH
A
B
E
4
1
(TT-R125E/TT-R125LWE)
3. Check:
1
• Install the starter clutch drive gear 1 onto
2
• When turning the starter clutch drive gear
• When turning the starter clutch drive gear
EC4L5000
ASSEMBLY AND INSTALLATION
CDI magneto
1. Install:
2. Install:
TIP
Apply the engine oil on the starter idle gear inner
circumference.
2
3
4-62
• Starter clutch operation
the starter clutch 2 and hold the starter
clutch.
counterclockwise B, the starter clutch and
the starter clutch drive gear should engage.
If the starter clutch drive gear and starter
clutch do not engage, the starter clutch is
faulty and must be replaced.
clockwise A, it should turn freely. If the
starter clutch drive gear does not turn freely,
the starter clutch is faulty and must be
replaced.
• Stator 1
• Bolt (stator)
10 Nm (1.0 m · kg, 7.2 ft · lb
• Lead guide
• Screw (lead guide) 2
7 Nm (0.7 m · kg, 5.1 ft · lb)
• Pickup coil 3
• Bolt (pickup coil)
10 Nm (1.0 m · kg, 7.2 ft · lb
• Stater idle gear 1
• Plate 2
• Bolt 3
7 Nm (0.7 m · kg, 5.1 ft · lb)
• Washer 4
ENG
Publicité
Chapitres
