Technical Information; Setting-Up And Adjustment - Scheppach HS720 Mode D'emploi D'origine

Technical information

Construction measurements:
Total length mm
Total width mm
Total height mm
Rocker support mm
Saw blade Ø max. mm
Idle - Motor 1/min.
Cutting speed- Saw blade m/sec.
Weight
Power unit:
Motor V
Input power P1 KW
Output power P2 KW
Motor speed 1/min.
Operating mode
Rated current A
Work information
Cutting height
Spar max. mm
min. mm
Turning cut max. mm
Piece of wood max. mm
Specific noise values
The according to the EN 23746 for the sound pressure level resp. EN 31202 (correction factor k3 after supplement A.2
from EN 31204 calculated) for the sound pressure level on the working site ascertained noise emission value amounts
under the foundations of ISO 7904 supplement A performed working conditions to:
Sound pressure level in dB
Idle LWA / Processing LWA
dB(A)
Sound pressure level on working site in dB
Idle LpAeq / Processing LpAeq
dB(A)
The specified values are emission values and therefore should not at the same time be reliable working site values. Although
there is a correlation between emission and immision levels, it cannot unfailingly be derived if extra precautions need to be
taken or not. Factors, which influence the actual availabe immusion value on working site, include the peculiarities of wor-
king area, other sources of noise, e.g. the number of machines and other adjoining processes. The allowed working values
could vary from country to country. However, the information should qualify the user, to be able to make an estimation of the
dangers and risks.
Assembly
The machine is delivered, except for the handle bar, completely assembled and is therefore immediately ready to operate.
Demount the handle bar from the rocker joint and insert it into the left frame side wall.

Setting-up and adjustment

Please pay attention that your rocker circular saw is set up stable and on a leveled floor.
Seite:12
230V
1270
730
1130
670
700
1400
52
kg 81
220-240 / 50Hz
2,1
1,5
1400
S6/40%
10
240
60
250
380x240
85 / 92
Technical information
Construction measurements:
Total length
Total width
Total height
Rocker support
Saw blade Ø
Idle - Motor
Cutting speed- Saw blade m/sec.
Weight
Power unit:
Motor
Input power P1
Output power P2
Motor speed
Operating mode
Rated current
Work information
Cutting height
Spar
Turning cut
Piece of wood
105 / 107 105 / 107
95 / 97 95 / 97
400V
mm 1270
mm 730
mm 1130
mm 670
max. mm 700
1/min. 1400
52
kg 92
V 380-420 / 50Hz
KW 5,2
KW 3,58
1/min. 1400
S6/40%
A 10
max. mm 240
min. mm 60
max. mm 250
max. mm 380x240
105 / 107
95 / 97