Technical Data - Dräger X-pid 8x00 Notice D'utilisation

9

Technical data

Excerpt: See the technical manual for details
Ambient conditions:
during operation 14 to 95 °F (-10 to +35 °C)
700 to 1300 hPa
10 to 90 % (up to 95 % short-term) rel. hum.
Orientation any
Degree of protection IP 54
The gas inlet openings and gas outlet opening
must be protected against liquids and contami-
nation.
The water and dust filter must always be fitted
during operation.
Operational readiness:
The operational readiness consists of various phases, some of which run
simultaneously. Operational readiness is typically given after 10 minutes, as
the heat-up phase and temperature stabilization are complete before the end
of the start-up phase.
Start-up phase 10 minutes
Used to stabilize the sensors and includes a
flushing phase at the end. After 10 minutes, the
start-up phase, incl. flushing phase, is com-
pleted. The start-up phase runs automatically
after turning on the sensor unit.
Flushing phase Typically 45 to 80 seconds
Used for flushing the gas chromatograph
between measurements, during the start-up
phase, and after exiting the standby mode.
Dräger X-pid
®
8x00 Sensor Unit
Heat-up phase Typically 3 to 4 minutes
Used to bring a cold device to operating tem-
perature, and runs automatically after the sen-
sor unit is turned on, at the same time as the
start-up phase.
Temperature stabilization Typically 2 to 3 minutes
Used to stabilize the operating temperature if it
was previously too low or too high (e.g. after the
heat-up phase).
Operating time Typically 3 to 6 hours under normal conditions.
The operating time reduces at low tempera-
tures.
Dimensions approx. 5,19 x 11,06 x 2,20"
(132 x 281 x 56 mm) (W x H x D)
Weight approx. 1,94 lbs (880 g)
Technical data