Mobile App; Status Led - Dräger X-pid 8x00 Notice D'utilisation

1 Power button
2 Back button
3 Home button
3.1.4

Mobile app

The mobile app is a native software application for Android and pre-installed on
the control unit contained in the scope of supply of the Dräger X-pid xx00. The
mobile app is developed and tested for the ecom Smart-Ex® 01 and is only
approved for this model. Installation on other terminals is not possible.
Dräger X-pid
4 Selection button
5 Touch display
®
8x00 Sensor Unit
3.1.5

Status LED

The status LED displays various signals depending on the device and
connection status of the sensor unit and mobile app.
Status LED
Off
Pulsing
Alternating:
Pulsing and
double blinking
On (continuous
light)
Blinking
Flashing
Sequence: lit,
rapid blinking for
2 s and blinking
Rapid triple
blinking for 6 s
Description
Description
Turned off
Sensor unit is turned off.
Charging
Sensor unit is turned off and is being
charged.
Charged
Sensor unit is turned off and fully
charged. Charging cable is con-
nected.
Connected
Sensor unit is turned on and con-
nected to the mobile app.
Not connected
Sensor unit is turned on, but not con-
nected to the mobile app.
Standby mode
Sensor unit is turned on, connected to
the mobile app, and in standby mode.
Connection failed
Sensor unit is turned on, but the con-
nection to the mobile app has failed.
Sequence only for a short time follow-
ing a failed connection attempt.
Sensor unit identified
Sensor unit is connected and the
Flashing button on the mobile app
dashboard has been pressed to iden-
tify the connected sensor unit.