4.2.2
Turning the sensor unit on
1. Hold down the on/off button for 3 s.
The status LED flashes as long as the sensor unit is not connected to
the control unit or the mobile app (the status LED flashes
After it is turned on, the sensor unit is automatically in the start-up and
heat-up phase, even if it is not yet connected to the mobile app.
4.2.3
Turning the sensor unit off
1. Hold down the on/off button for 3 s until the status LED goes out.
● Alternatively, the sensor unit can be turned off in the mobile app, assuming it
is still connected.
NOTICE
Deep discharge
The charge status of the sensor unit must be checked at least every two months
in order to prevent a deep discharge. The sensor unit cannot be turned on if the
rechargeable battery is completely discharged.
► Charge the sensor unit.
4.2.4
Turning on the control unit
1. Hold down the power button for 3 s.
The display is activated and several logos appear in succession.
The display with the time appears.
2. Swipe up with your finger and unlock the display.
The home screen appears.
The mobile apps (Dräger App Store and Dräger X-pid xx00 mobile app)
appear.
4.2.5
Turning off the control unit
1. Hold down the power button for 3 s.
A pop-up with the turn off button appears.
Dräger X-pid
).
®
8x00 Sensor Unit
2. Select Turn off.
An acoustic signal sounds.
The ecom logo appears.
The screen turns black.
NOTICE
Deep discharge
The charge status of the control unit must be checked at least every 9 months in
order to prevent a deep discharge. The control unit cannot be turned on if the
rechargeable battery is completely discharged and the display does not show
any charging process.
► Connect the control unit to the battery charger. The display turns on after a
few minutes of charging time.
► Turn on the control unit.
► Pay attention to this and additional safety information for the control unit.
4.2.6
Starting or opening the mobile app
Starting (for the first time or if the mobile app has been exited):
1. Select the mobile app icon with the Dräger X-pid xx00 subscript on the
home screen.
The Dräger logo appears.
The Measure view is automatically displayed.
Opening (if the mobile app has been closed or minimized):
1. Select the mobile app icon with the Dräger X-pid xx00 subscript on the
home screen.
The Measure view is automatically displayed.
4.2.7
Closing or exiting the mobile app
Closing or minimizing:
1. Press the home button on the control unit.
The home screen appears.
The mobile app has been minimized and remains active in the
background.
Operation