Adjusting The Sound; General Settings - Psm - JVC KD-AR480 Manuel D'instructions

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
2
Indication, [Range]
BAS* 2 (bass), [–06 to +06]
Adjust the bass.
MID* (mid-range), [–06 to +06]
2
Adjust the mid-range frequencies sound level.
TRE* 2 (treble), [–06 to +06]
Adjust the treble.
FAD* 3 (fader), [R06 to F06]
Adjust the front and rear speaker balance.
BAL* 4 (balance), [L06 to R06]
Adjust the left and right speaker balance.
S.BS* 2 (super bass), [S.BS ON or S.BS OFF],
[01 to 05, initial: 03]*
Maintain the richness and fullness of the bass sound
regardless of how low you set the volume.
SUB.W* 1 (subwoofer), [00 to 08, initial: 04]
Adjust the subwoofer output level.
VOL (volume), [00 to 30 or 50*
Adjust the volume.
*
1 Displayed only when "L/O MODE" is set to "WOOFER"
(see page 14).
*
2 When you adjust the bass, mid-range, treble, or super
bass, the adjustment you have made is stored for the
currently selected sound mode (iEQ) including "USER."
*
3 If you are using a two-speaker system, set the fader
level to "00."
12
5
6 ]
*
4 This adjustment will not affect the subwoofer output.
*
5 Range adjustment for super bass is adjustable only
when it is set to "S.BS ON."
* Depending on the amplifier gain control setting. (See
6
page 14 for details.)
General settings — PSM
You can change PSM (Preferred Setting Mode) items
(except "SID") listed in the table that follows.
1
2
Select a PSM item.
3
Adjust the PSM item selected.
4
Repeat steps 2 and 3 to adjust other PSM
items if necessary.
5
Finish the procedure.