Setup Menus; Navigating The Setup Menu - Arcam AV860 Manuel

setup menus

The Setup menus allow you to configure all aspects
of your Receiver. The next few pages will go through
the menu items and explain their function. The Setup
menus will probably look quite daunting if you are new
to setting up home cinema, but the majority of them
need only be configured once when you first install the
system (or if your system changes or you move house!)
The only way to view the Setup menus is on your display
device (TV or projector) using the on-screen display
(OSD) capability of the Receiver. To view the OSD for
the initial setting up, connect any of the video outputs
to your display device. You do not need to have a video
source connected to the Receiver video inputs.
Entering Setup mode
To enter the setup menu, press the button on the
MENU
remote control or font panel. The front panel display
shows ' SETUP MENU ' and the setup menu (pictured
right) is displayed.
Menu panel
The left-hand panel lists the setup
screens available for adjustment. The
selected menu is highlighted with a grey
band.
Input Config
Source Input
General Setup Incoming format
Speaker Types Incoming sample rate
Incoming bitrate
Speaker Distances
Speaker Levels Dialnorm
Video Inputs Video Input
HDMI Settings Incoming resolution
Audio compression
Mode
Zone Settings Balance
Network
Direct selection of the video input without changing the audio input.
Help screen
The lower right-hand panel gives a short
help text for the feature being adjusted.

Navigating the setup menu

... using the remote control
The setup menu can be navigated by using the cursor
(arrow) keys on the remote control. This is by far the
easiest method.
1. To enter the setup menu, press the
MENU
(which is located immediately under the navigation
buttons).
2. Use the ' and , keys to navigate up and down
the main section headings in the left-hand panel.
3. Once you have the main section that you require
highlighted, use the > key to enter the section.
4. Use the ' and , keys to navigate up and down
the section settings in the right-hand panel. Some
settings may be greyed out. These are either for
information only (e.g. incoming sampling frequency)
E-28
Adjustment panel
The upper right-hand panel lists the
parameters you can change as a user.
The selected line is highlighted with
a black band. Lines that cannot be
selected are greyed-out.
BD
Scroll bars
Dolby Atmos 7.1.4
192kHz Out: 96kHz These indicate the
Lossless
position of the
--
displayed screen
BD
within longer menus.
1080p50
Off
0dB
or are not currently selectable (e.g. network IP
address when DHCP is used). Scroll bars on the
sides of the right hand panel indicate your position
in the settings list where there are more items than
can be displayed at once.
button
5. Pressing OK selects a setting to change it, pressing
again de-selects the setting.
6. At any time, press the MENU button to exit the menu.
Any changes to settings are saved.
... using the keys on the front panel
The Receiver front panel controls can be used to
configure the unit. Follow the instructions for using
the remote control, in this case using
INPUT+ for up, INFO for left and MODE
OK
for down,
INPUT–
for right.