Safety Of Others - Black & Decker KA1000 Traduction Des Instructions D'origine

power tool will do the job better and safer at
the rate for which it was designed.
b. Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
c. Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e. Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g. Use the power tool, accessories and
tool bits etc., in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
5. Service
a. Have your power tool serviced by
a qualifi ed repair person using only
identical replacement parts. This will ensure
that the safety of the power tool is maintained.
Additional power tool safety warnings
Warning! Additional safety warnings for
sanders
Hold the power tool by insulated gripping
♦
surfaces, because the sanding belt /
sanding base may contact its own cord.
Cutting a "live" wire may make exposed metal
parts of the power tool "live" and could give the
operator an electric shock.
Use clamps or another practical way to
♦
secure and support the workpiece to
a stable platform. Holding the work by hand
or against your body leaves it unstable and
may lead to loss of control.
Warning! Contact with or inhalation of
♦
dusts arising from sanding applications may
endanger the health of the operator and
possible bystanders. Wear a dust mask
specifi cally designed for protection against
dust and fumes and ensure that persons within
or entering the work area are also protected.
Thoroughly remove all dust after sanding.
♦
Take special care when sanding paint which
♦
is possibly lead based or when sanding some
woods and metal which may produce toxic dust:
- Do not let children or pregnant women enter
the work area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris
safely.
This tool is not intended for use by persons
♦
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children should be
supervised to ensure that they do not play with
the appliance.
The intended use is described in this
♦
instruction manual.
The use of any accessory or attachment
or performance of any operation with this
tool other than those recommended in this
instruction manual may present a risk of
personal injury and/or damage to property.

Safety of others

This appliance is not intended for use by
♦
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
♦
they do not play with the appliance.
Residual risks.
Additional residual risks may arise when using the
tool which may not be included in the enclosed
safety warnings. These risks can arise from
misuse, prolonged use etc.
ENGLISH
33