Electrical Safety - Black & Decker KA1000 Traduction Des Instructions D'origine

ENGLISH
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be avoided.
These include:
Injuries caused by touching any rotating/
♦
moving parts.
Injuries caused when changing any parts,
♦
blades or accessories.
Injuries caused by prolonged use of a tool.
♦
When using any tool for prolonged periods
ensure you take regular breaks.
Impairment of hearing.
♦
Health hazards caused by breathing dust
♦
developed when using your tool (example:-
working with wood, especially oak, beech
and MDF.)
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with
a standard test method provided by EN 60745 and
may be used for comparing one tool with another.
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool
along with the date code:
Warning! To reduce the risk of injury, the
user must read the instruction manual.

Electrical safety

This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to the
voltage on the rating plate.
34
If the supply cord is damaged, it must be
♦
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to
avoid a hazard.
Features
This tool includes some or all of the following
features.
1. On/off switch
2. Dust cassette
3. Base
4. Tip holder
5. Sanding base tip
6. Finger attachment
7. Profi le attachment
8. Screw
9. Sanding profi les
In addition, this tool is supplied with some or all of
the following accessories:
Accessories
The accessories supplied with your sander depend
upon the model that you have purchased.
All the accessories listed below are available
in our Piranha ® range. If you require an accessory
that is listed below but is not supplied with your
sander please visit our website at
www.blackanddecker.eu.
Item Description
Detail fi nger.
For small hard-to-reach areas.
The detail fi nger can be used for
light sanding and for sanding into
corners.
Sanding profi le attachment.
An attachment to hold the
various profi les listed below.
Concave curved sanding
profi le.
For detailed sanding to suit this
shape.
Convex curved sanding
profi le.
For detailed sanding to suit this
shape.
Pointed curved sanding
profi le.
For detailed sanding to suit this
shape.