Ordering Replacement Parts; Disposal And Recycling - EINHELL EURO 4000/1 Mode D'emploi

Anleitung Euro 4000 SPK1
Possible causes of
machine failure
Overloading of the motor and
hence triggering of the overload
circuit-breaker may result from:
● An excessively high mains
voltage
● Excessively high ambient
temperatures and an insufficient
air supply
● Defective compressor valves or
a leaking non-return valve
● A low level of oil, sluggish
connecting rod bearings
Leave a.c. motors enough time to
cool off before switching on again.
Avoid touching hot components
and pipe lines.
Ordering replacement
parts
Please quote the following data
when ordering replacement parts:
● Type of machine
● Article number of the machine
● Identification number of the
machine
● Replacement part number of
the part required

Disposal and recycling

The unit is supplied in packaging
to prevent its being damaged in
transit. This packaging is raw
material and can therefore be
reused or can be returned to the
raw material system.
The unit and its accessories are
made of various types of material,
such as metal and plastic.
Defective components must be
disposed of as special waste. Ask
your dealer or your local council.
23.11.2006 14:29 Uhr Seite 13
GB
13