Changing The Thrust Direction - Vetus BOW PRO B Série Instructions D'installation

n
ote
6 .9

Changing the thrust direction

If, during the test run, it appears that the movement of the boat is
contrary to the direction in which the joystick is moved, reconfigure
as follows.
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the On / Off button once to switch the panel
to the OFF position.
1
10 seconds
1 Place the panel in configuration mode
• Press and hold the On / Off button for 10 seconds.
2
2 x
2 Press the On/Off button twice.
4 When the red LED at the upper
left is on: Push the joystick to
the left once. The green LED at
the upper right will now go on
and the thrust force direction is
changed.
OR
5 When the green LED on the up-
per right is on: Push the joystick
to the right once. The red LED
at the upper left will now go on
and the thrust force direction is
changed.
32
020808.02
Always set up the following two configurations
first: - whether the panel is to operate a bow or a
stern thruster (see section 6 .7), and
dididididididid ( . . . . . . )
6 seconds
didahdi ( . − . )
4
RED
5
GREEN
vetus® Installation instructions BOW PRO Series Thrusters: BOWB065, BOWB076, BOWB090, BOWB110 and BOWB130
- which helm station the panel is situated in (see
section 6 .8) . Thereafter, if necessary, change the
thrust force direction .
Settings are retained even if the supply voltage is switched off!
BPPPA
4 seconds
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -). Now the panel is in
configuration mode.
3
3 The LED next to the On/Off button will now start flashing simulta-
neously blue and red.
GREEN
1 x
RED
1 x
n
ote
ON/OFF ON/OFF
BPPJA
dididididah ( . . . . − )
Con guration mode
BLUE and RED,
simultaneously
ashing
6
1 x
6 Press the On/Off but-
ton once to confirm the
setting.