Power Save Mode - ResMed Lumis HFT Mode D'emploi

Drying mode
WARNING
• Remove the nasal cannula from your face before starting Drying mode because the air is
dry and may cause harm.
• Turn off supplemental oxygen at the source before starting Drying mode so that oxygen
does not accumulate and create a fire risk.

Power save mode

Your Lumis HFT device records your therapy data. In order to allow it to transmit the data to your
care provider, you should not unplug the device. However, you can put it into power save mode to
save electricity.
To enter power save mode:
• Press and hold Start/Stop for three seconds.
The screen goes black.
To exit power save mode:
• Press Start/Stop once.
The Home screen is displayed.
After stopping therapy, Drying mode will automatically start. This mode dries
the air tube and cannula so that it is ready for use next time.
During Drying mode, do not remove the humidifier water tub. The device will
automatically enter standby after 90 minutes.
While Drying mode is running you can view the Therapy Report by pressing
the Home button.
The device regulates the tube temperature to a medium value, whilst running
the humidifier at minimum power during the Drying mode.
English 9