ResMed Lumis HFT Mode D'emploi page 7

To remove supplemental oxygen:
1. Unlock the low flow oxygen input at the rear of the device by pushing down on the locking clip.
2. Remove the oxygen port connector from the low flow oxygen input.
Performing a functional check
With the device powered off:
• Check the condition of the device and accessories.
Inspect the device and all the provided accessories. If there are any visible defects, the system
should not be used.
• Check the air tubing setup.
Check the integrity of the air tubing. Connect the air tubing firmly to the air outlet and other
accessories if in use.
• Check the connection to the oxygen port.
Inspect the connection for cracks or leaks and that the port is stable.
•
Check the HumidAir humidifier.
Inspect the humidifier for cracks or leaks. If there are any visible defects, the humidifier should
be replaced.
6