Connecting To Mains Power; Accessories - ResMed Hospital Trolley Mode D'emploi

Fitting the base plate to the Astral device
Ensure the Astral is powered off before fitting the base plate.
1. Turn the Astral device upside down and place on a soft but stable
surface (to protect the LCD screen).
2. Position the base plate on the underside of the Astral device and
align the screw holes.
3. Secure the base plate to the Astral device using the M4 screws
and 2.5 mm hex key.
Fitting the base plate to the trolley table
1. Hold the Astral device (with base plate attached) by the handle
and place the back edge of the base plate underneath the trolley
table hooks.
2. Press down firmly on the handle of the Astral device so the base
plate clips down into the trolley table.
Notes:
• Do not press down on the LCD screen of the Astral device as it
may cause damage.
• To remove the Astral device from the trolley table, press the base
plate release button and lift up the Astral handle.

Connecting to mains power

To connect your device to mains power:
1. Remove the trolley rear panel.
2. Place your device PSU in one of the PSU holders.
3. Thread your device power cable through the upper cable port of
the trolley rear panel.
4. Connect the PSU into the power strip.
5. Replace and secure the trolley rear panel.
6. Connect the power cable to your device using the mains cable.
7 . Connect the power strip into mains power.
Connecting an Humidifier
1. Remove the trolley rear panel.
2. Place the humidifier PSU in one of the PSU holders.
3. Thread the humidifier power cable through the humidifier cable
port at the front of the trolley.
4. Slide the humidifier into the humidifier bracket.
5. Connect the humidifier PSU into the power strip.
6. Replace and secure the trolley rear panel.

Accessories

Circuit support arm
The circuit support arm is used to position and hold the patient
circuit during treatment.
To attach the circuit support arm:
Screw the end of the Circuit support arm into one of the Bennett
adapters on the Trolley Table.
English 3