Intended Use; General Warnings And Cautions - ResMed Hospital Trolley Mode D'emploi

Hospital Trolley
User Guide
ENGLISH

Intended use

The ResMed Hospital Trolley ('Trolley') is designed to hold and move
compatible ResMed ventilators and accessories between points
of therapy in the hospital environment and limited care facility
environments.

General warnings and cautions

• When fitting devices or accessories, or when stationary,
immobilise the trolley by locking all four wheels. Ensure all
wheels are unlocked before moving the trolley.
• Do not leave the trolley on a steep slope. Hold the trolley
handle as you move the unit over power cords or any other
obstacle to prevent accidental tipping.
• When using the trolley with other devices or accessories,
always refer to the user guides that come with those devices
for full instructions for use.
• If this trolley is modified, appropriate inspection and testing
must be conducted to ensure continued safe use of the trolley.
• Pushing with excessive force, especially while the wheels
are locked, may cause the trolley to topple over. This could
damage the ventilator and attached equipment
• Read the entire manual before using the trolley.
Note: For any serious incidents that occur in relation to this product,
these should be reported to ResMed and the competent authority in
your country.
The Trolley at a glance
Refer to illustration A, B, C and E.
1. Base plate
2. Intravenous (IV) support pole
(to support a 1L bag)
3. M5 grub screw
4. Trolley table hooks
5. Trolley table
6. Cable hook
7 . Centre console
8. Wheels (lockable)
9. Humidifier bracket
10. Humidifier cable port
11. Trolley handle
The Trolley comprises the following components:
• Trolley
• Base Plate
• IV Support Pole
• 3 mm hex key x1
• 2.5 mm hex key x1
• M5 grub screw x1
• M4 screw x2.
12. Base plate release button
13. Bennett connections
14. Power supply unit (PSU)
holder
15. Power supply unit (PSU)
holder
16. Trolley rear panel
17 . Upper cable port
18. Power strip mount
19. Lower cable port
20. Bracket strap
21. Cylinder mount base.
English 1