Preparing For Use; Setting U P The Auto Set Spirit - ResMed AUTOSET SPIRIT Manuel Utilisateur

P
REPARING FOR
S U T A
ETTING P HE
1
Place the A
UTO
CAUTION
!
Be careful not to place the device where it can be bumped or where someone is
likely to trip over the power cord.
Note: The AutoSet Spirit unit may be placed on the floor beside or underneath your bed.
Ensure that the area is free from dust and clear of bedding, clothes, or any other objects
that could block the air inlet.
2
Connect the power cord to the socket at the rear of the flow generator. Plug the other
end of the power cord into a power outlet.
WARNING
!
Make sure the power cord and plug are in good condition and the equipment is
•
not damaged.
The air filter cover protects the device in the event of accidental liquid spillage
•
onto the device. Ensure the air filter and air filter cover are fitted at all times.
3
Align the pressure sensor adapter with the pressure port. Fit the pressure sensor
adapter onto the air outlet of the unit.
4
Connect one end of the air tubing firmly onto the pressure sensor adapter.
U
SE
S S
UTO ET PIRIT
S S unit on a table near the head of your bed.
ET PIRIT
Pressure port
P U
REPARING FOR SE
11