ResMed Air10 Mode D'emploi

English | Deutsch | Français | Italiano | Español | Português | Nederlands | Svenska | Dansk | Norsk | Suomi |
1
C
B
English
The DC/DC Converter 90W allows you to operate your
device from a vehicle cigarette lighter socket (12V or 24V
DC power source) in a car, boat, or other vehicle equipped
with a suitable battery.
The Air10 DC/DC Converter 90W (model no. 37003,
illustration 1) is specifically for use with an AirSense
or AirCurve 10 device and the S9 DC/DC Converter 90W
™
(model no. R360-792, illustration 2) is specifically for use
with an S9 device.
™
The DC/DC converter 90W comprises the following
elements:
• DC/DC Converter 90W
• Battery clips.
Compatibility table
Air10 Converter -
product # 37297
(illustration 1)
S9 Converter - product
# 36970
(illustration 2)
E
D
AirSense 10 /
AirCurve 10
2
A
D
Consult your equipment supplier for more information
about this accessory.
Using the converter via a vehicle cigarette
lighter socket
Refer to illustration 1 for the Air10 converter and
illustration 2 for the S9 converter. Illustrations are at the
10
™
beginning of this document.
1. Before connecting the converter, make sure the
converter switch (A) is off.
2. Position the converter on a level surface, with the
ResMed logo facing up.
3. Plug the converter connector (B) into the device power
inlet/DC input socket (C).
4. Remove the cigarette lighter from the vehicle cigarette
lighter socket.
5. Plug the converter adaptor plug (D) into the vehicle
S9
cigarette lighter socket.
6. Switch on the converter. The light (E) will glow green
when it powers on.
The light will flash continuously if the connection is not
made, or if the device is in standby or power save mode
when the connection is made. If the battery is low,
the light will glow amber. If the light does not operate,
check that the converter switch (A) is on.
DC/DC Converter 90W
Česky | Eesti |
简体中文
B C
A
Air10 and S9
User Guide
| |
日本語
繁體中文
E