Recommended Naída Ci Operating And Storage Temperatures; Approved Power Sources; Troubleshooting The Naída Ci - Advanced Bionics Naida CI Q70 Mode D'emploi

3
Carefully pull the tool out of the opening.
The microphone cover should come out
with the tool. The cover can be removed
from the tool and then disposed of.
Replacing the Microphone Cover
1
Grasping the tool in one hand, use the blunt,
non-threaded end to put a new microphone
cover on the end of the tool. The microphone
cover is quite small, so the tool works as a
guide to properly and easily replace the cover.
3
Press the cover into the hole until the tool is
flush with the processor.
52
Naída CI Sound Processor User Guide
2
With the microphone cover on the end
of the tool, hold the Naída CI in the
other hand and carefully align the end
of the tool directly over the opening to
the microphone.
4
Carefully pull the tool away from the
processor, leaving the microphone cover
correctly seated in the microphone port.
Recommended Naída CI Operating and Storage Temperatures
Operating and Storage Temperature Ranges
Condition
Operating temperature
Storage temperature

Approved Power Sources

Advanced Bionics has verified the Naída CI to function with the power sources listed below;
behavior when using power sources other than those listed here cannot be guaranteed.
Approved Naída CI Power Sources
Power Source
PowerCel
Zn-Air
Programming Interface
(used during fitting, only)
Approved Naída CI Power Supplies
Power Supply Rated Voltage
PowerCel 3.7 V
Zn-Air 2.8 V
Programming Interface 5.0 V
Troubleshooting the Naída CI
If no sound is heard or the red LED is flashing once per second on the Naída CI processor LED
when the headpiece is in place over the implant, try the following troubleshooting steps:
Visually inspect the cable for any damage or breakage and verify it is firmly attached to
1
the headpiece and sound processor.
Remove any materials (hat, scarf, headband, etc.) that may be covering the microphone.
2
Unaided listeners may perform a listening check of the microphones as described in the
3
Listening to the Microphone and Auxiliary Input
Minimum Maximum
0°C (32°F) 45°C (115°F)
-20°C (-4°F) 55°C (131°F)
Model Number Capacity (mAhr)
CI-5511-XXX
110
CI-5517-XXX 170
CI-5523-XXX 230
1,140
PowerOne p675
Not Applicable
CI-6101
Type Rated Energy
Li-ion (Rechargeable) 0.4 Wh – 0.9 Wh
Zn-Air (Disposable) 1,240 mWh
DC
section of the User Guide.
Naída CI Sound Processor User Guide
1,250 mW
53