Assembling The Powercel Charger; Inserting The Powercels Into The Charger; Removing The Powercels From The Charger - Advanced Bionics Naida CI Q70 Mode D'emploi

Do not connect the Zn-Air Battery Pak to the charger. The charger is
WARNING:
to be used with the rechargeable Lithium Ion PowerCels only. All three sizes of Lithium
Ion PowerCels can be used on the PowerCel Charger.

Assembling the PowerCel Charger

Power supplies and battery chargers should be operated in an open area to
WARNING:
ensure adequate airflow. While, to date, no injuries have been reported, during normal
use in the event of a fault, components may become hot. If the device's temperature
results in discomfort or pain when touched, disconnect the power source and contact AB.
Only use the charger provided for charging AB PowerCels. Do not use it
CAUTION:
to charge other batteries. Do not try to charge Naída CI PowerCels using a charger
other than that provided by Advanced Bionics.
Battery Charger
USB
Power Supply
The charging system consists of the charger, power supply, and power supply adapters. The
charger can also be used with the power supply removed from the cable, exposing the USB jack
so it can be powered from any USB port.
Charging Information for Lithium Ion Batteries:
The charger provided with the sound processor is designed to charge up to four PowerCels
simultaneously. It takes approximately 2-3 hours to fully charge a depleted PowerCel. This will
vary slightly for different PowerCel types.
42
Naída CI Sound Processor User Guide
Power Supply Adapters
The PowerCels do not need to be fully depleted before recharging.
It is recommended that you use and recharge the PowerCel(s) at least once every three months.
Please note that PowerCels will decrease in capacity with age, even if not in use. This is normal
for all rechargeable batteries and should not be considered a defect.
NOTE FOR EUROPEAN CUSTOMERS:
Europe, please return depleted batteries to the nearest AB representative or a designated
programming/follow-up center.
In the United States and Canada, please call the Rechargeable Battery Recycling Corporation
hotline at 877.273.2925 or visit their website at www.call2recycle.org.

Inserting the PowerCels into the Charger

1
Locate the slide tracks on the charger.
Position the PowerCel so that the
battery contact is facing down toward
the base of the charger.

Removing the PowerCels from the Charger

1
Gently slide the PowerCel out of the
slide tracks of the charger, sliding
toward the outer edge of the charger.
For proper disposal of rechargeable batteries in
2
Slide the PowerCel along the tracks
until it engages. The charger is
designed so the PowerCels can only be
inserted in one direction.
Naída CI Sound Processor User Guide
43