Removing The T-Mic 2/Earhook; Attaching The T-Mic 2 Cover; Removing The T-Mic 2 Cover - Advanced Bionics Naida CI Q70 Mode D'emploi

5
Pull the tool away from the processor,
leaving the pin inside the Naída CI.

Removing the T-Mic 2/Earhook

1
Remove the power source. Align the
pointed end of the T-Mic 2/Earhook
tool with the hole on the processor that
contains the pin holding the T-Mic 2/
Earhook on the Naída CI processor.
3
The pin does not need to be fully
removed from the processor. As long
as the tool was pushed in flush on one
side of the processor, the pin should
be displaced enough for the T-Mic 2/
Earhook o be removed.
18
Naída CI Sound Processor User Guide
2
Gently press the tool in the hole, pushing
the pin out the other side.
4
Remove the tool from the Naída CI.
Gently grasp the T-Mic 2/Earhook at
the top near where it connects with the
processor and pull forward, until it is
separated from the processor.

Attaching the T-Mic 2 Cover

1
Hold the T-Mic 2 Cover in one hand. In
the other hand, hold the T-Mic 2 at the
end that houses the microphone. Align
the bottom of the T-Mic 2 over the
T-Mic 2 Cover.
3
Once resistance is felt, stop turning.

Removing the T-Mic 2 Cover

1
Grasp the end of the T-Mic 2 where the
T-Mic 2 Cover is located, in one hand.
Firmly hold the T-Mic 2 microphone
portion in the other hand.
2
Gently turn the T-Mic 2 Cover clockwise
into the T-Mic 2 Cover. Screw until the
parts meet together flush.
2
Turn the hand holding the T-Mic 2 Cover
counter-clockwise to slowly unscrew the
T-Mic 2 Cover from the T-Mic 2.
19
Naída CI Sound Processor User Guide