The Zn-Air Battery Pak; Inserting Zn-Air Batteries; Inserting Zn-Air Batteries (Tamperproof Cartridge) - Advanced Bionics Naida CI Q70 Mode D'emploi

Masquer les pouces Voir aussi pour Naida CI Q70:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35

The Zn-Air Battery Pak

The Naída CI uses size 675 Power Implant disposable batteries (675P). Regular size 675
hearing instrument batteries will not be powerful enough for a cochlear implant.

Inserting Zn-Air Batteries

1
Holding the Zn-Air Battery Pak in one hand,
gently but firmly push down on the lever on
the back of the battery cartridge. This will
cause the drawer to pop out of the bottom
of the cartridge.
Remove the Zn-Air batteries from their package, making sure to remove the tape from the flat
3
positive (+) side of the cell. Removing the tape allows oxygen to flow in and activate the battery, so
be sure to install it immediately after peeling off the tape.
4
Place two Zn-Air batteries, positive (+)
(flat) side up, in the two openings in the
battery drawer.
Note: If the cells are inserted incorrectly, the battery drawer will not close.
44
Naída CI Sound Processor User Guide
2
Pull the battery drawer out of the
cartridge with the other hand.
5
Once the batteries are flush with
the top of the battery drawer, gently
slide the battery drawer back into the
battery cartridge.
6
Attach the battery cartridge to the Naída CI following the same instructions as attaching the
PowerCels to the Naída CI in the section

Inserting Zn-Air Batteries (Tamperproof Cartridge)

1
Use the same tool provided for T-Mic 2/
Earhook removal and replacement—Insert
the pointed end of the tool into the small
hole located on the spine of the Zn-Air
Battery Pak. Note: If you do not have the
tool present, any thin pointed device should
work to release the drawer.
3
Set the tool aside and grasp the Zn-Air
Battery Pak drawer with your hand and
gently pull it the rest of the way out.
To insert the batteries, follow instructions Step 2 to 5 of the previous section
Replacing the Battery.
2
With the tool inserted in the hole, gently
push in and downward until you feel
the Zn-Air Battery Pak drawer release
and the button of the Zn-Air Battery
Pak pops out.
Inserting Zn-Air Batteries.
Naída CI Sound Processor User Guide
45

Publicité

Table des Matières
loading

Table des Matières