GE GLE12HSLSS Manuel D'utilisation Et Instructions D'installation page 27

Accessory Installation Instructions
Troubleshooting Tips... Before you call for service
Problem
Leaking water around the
fill cup
Leaking water behind the
refrigerator
Slow ice/freezer not cold
enough
Ice cubes too small/ slow
ice
Ice cubes not landing in
bucket
Ice cubes have odor/taste
Frequent "buzzing" sound
49-60769
Possible Causes
Foam in the fill cup from
installing the fill tube.
Fill tube not correctly seated in
the fill cup.
House supply not properly
connected to the water valve.
Water line not connected to the
water tube inlet.
Door left open.
Temperature control not set
cold enough.
Water shutoff valve connecting
refrigerator to house water line
may be clogged.
Water line kinked.
Icemaker cord causing
icemaker/ bucket misalignment
Ice storage bin needs cleaning.
Food transmitting odor/taste to
ice cubes.
Interior of refrigerator needs
cleaning.
Normal operation.
What to Do
If the fill tube was installed by sliding
it through the back of the
refrigerator, it may have picked up
pieces of foam as it was pushed
through. This foam can interfere
with the water flow in the fill cup.
Check the cup and make sure
there are no foam pieces.
Check that the fill tube is correctly
inserted in the fill cup
opening. See "Mount the
icemaker" in the Installation
Instructions.
Check that the house supply is firmly attached to the water
valve. See Water line installation instructions.
Check that the plastic water line
running from the valve to the
water tube inlet is firmly
attached with the water line.
Check to see if package is holding door open.
See Controls on page 5.
We recommend drilling a 1/4" hole in
the water pipe to connect the water
shut-off valve. Failure to drill a 1/4" hole
may result in reduced ice production or
smaller cubes. See Installing the water
line.
Check that the plastic water
line running from the valve to
the water tube inlet is not
kinked. See "Connect the
water line" in the Installation
Instructions. A kink in the
water line will restrict flow to
the icemaker.
Be sure icemaker power cord is in the hook as stated in the
Installation Instructions.
Empty and wash bin. Discard old cubes.
Wrap foods well.
See "Care and cleaning" in the Owner's Manual of the
refrigerator.
During normal operation, the water valve will "buzz" when the
icemaker fills with water.
Fill Tube
Fill
Tube
Fill Cup
Water
Tube Inlet
Hose Clamp
Water Line
Drill 1/4" hole
in water pipe
Adhesive-backed
Fasteners for
Water Tube
27