RADWAG R Série Mode D'emploi page 8

Balance with pan Φ 115 mm
Upon unpacking, remove all transport locks and assembly the following elements:
- draft shield (1)
CAUTION!
While cleaning it is advisable to follow below precautions. Additionally it is a must to disconnect the device from
mains and unplug all the peripherals (printers, computer etc.) remembering at the same time to protect ports by
means of stoppers. Only thus prepared device can be cleaned. Upon completion of the cleaning process the
device may be connected to mains for further operation.
Balance with pan 195x195 mm
- weighing pan shield (3) and weighing pan
(2)
- plug the power supply connector into the
socket (4),
- plug the power supply to the mains.
- 8 -